Check of inner diameters of pipes, model MA
TECHNICAL DATA1
| Calibrated diameter | ø 2 - 70 mm |
| Equipment dimensions: | |
| Sensing unit I. max ø 20 | ø 60 x 200 mm |
| Sensing unit II. max ø 70 | ø 140 x 225 mm |
| Evaluating part (l x w x h) | 200 x 115 x 170 mm |
| Electrical voltage | 230 V, 50 Hz |
| Power input | 20 kVA |
USE
The apparatuses are used for checking the inner diameter of tubes produced by means of extrusion. They check the inner diameter minimum value.
FUNCTION:
The equipment consists of the sensing part, calibration pin, and evaluating part. The calibration pin determines the minimum value of the inner diameter of a checked tube. The pin is kept in the tube in a working position by means of a strong magnetic field. In the event that the inner diameter drops below the calibrated value, the pin is moved towards a sensor and the evaluating part signals a failure. The defective part of the tube is removed and the pin is again moved to its working position. In the case of a diameter of tubes exceeding 30 mm, the data transmission to the evaluating part is wireless within a distance of 40 m.
ADVANTAGES:
When using the equipment, the additional checking of the tube inner diameter is not required as the tubes are checked in the course of the production. This reduces the costs and the possibility of a complaint from the customer.
The sensing part can be produced according to individual requirements, also can be put into production line control system.
1 ) Changes in technical parameters reserved.